As is often the case, I've been distracted by many other things so not much has happened over the last few weeks until yesterday when I started wiring up the final board. Typically I realised that where I needed to put a point motor there was a cross brace...
I'd planned ahead with one though so already had the right hole at the other end of the boards.
Fortunately it wasn't as difficult to remove as I was expecting.
And finally proof that the underneath of the board isn't a complete mess...
I'd planned ahead with one though so already had the right hole at the other end of the boards.
Fortunately it wasn't as difficult to remove as I was expecting.
And finally proof that the underneath of the board isn't a complete mess...
Comments
Post a Comment